Wayne-Dalton TORSION SPRING 9800 - Manual (Page 4)

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at 1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
4
tools Needed: NOTE: this provides an alternative method
for identifying your door sections/stacking
position.
hinges are always pre-attached at the top
of each section (except top section) and
the hinges are stamped for identification,
#1, #2, #3, and #4 (#4 only on five
section doors). See view below. the
stamp identifies the stacking sequence
of the section. the sequence is always
determined by #1 being the bottom
section to #3 or #4 being the highest
intermediate section. See views to the
right. If the stamp on the end hinge is
illegible, refer to the section side view
illustration to the right.
the section side view illustration shows
the end hinge profile of all the sections,
and can also be used in conjunction with
identifying each sections.
the bOTTOM sECTION can be identified
by #1 end hinges, the factory attached
bottom astragal and the bottom bracket
warning labels on each end stile.
the lOCk sECTION can be identified by a
#2 end hinge.
the INTERMEDIATE sECTION can be
identified by #3 end hinges. the section
will have a warning label attached to
either the right or left hand end stile.
NOTE: #4 End hinges are used on the
fourth section of five section doors.
the TOP sECTION can be identified with
no pre-installed end or center hinges and
u-bar attached to the top section.
SECTION SIdE vIEw
TyPICAl hINGE sTAMPING lOCATION
Door section Identification
1 3/8” 1 1/8” 7/8”
#1 END
hINGE #2 END
hINGE #3 END
hINGE
aStRaGal
bOttOM
bRaCkEt
bOt. lOCk INt. tOP
u-baR
tOP SECtION
INtERMEDIatE SECtION
lOCk SECtION
bOttOM SECtION
bOttOM bRaCkEt
WaRNING labElS
aStRaGal
#3
WaRNING labEl
(May bE ON RIGht OR lEft haND SIDE)
#2
#1