White Rodgers 1F92W-51 User Manual
Page 16
16
ATTACH THERMOSTAT TO SUBBASE
WE RECOMMEND THAT YOU SET OPTION
SWITCHES TO DESIRED POSITION BEFORE AT-
TACHING ON SUBBASE (see OPERATION). WE
ALSO RECOMMEND THAT YOU PROGRAM THE
THERMOSTAT WITH BATTERY INSTALLED BE-
FORE ATTACHING ON SUBBASE (see OPERA-
TION section for programming instructions).
USE
SYSTEM
HEAT-OFF-COOL-AUTO
TO TURN THERMOSTAT OFF BE-
FORE ATTACHING TO WALL. FAILURE TO TURN
OFF THERMOSTAT BEFORE ATTACHING TO
WALL MAY CAUSE EQUIPMENT DAMAGE DUE
TO RAPID COMPRESSOR CYCLING.
To attach thermostat to subbase, line up the plastic
snap guides at the top of the thermostat and the 4
connector pins on the thermostat with the connec-
tors near the top right section of the subbase (when
viewed from the front). Gently pivot the thermostat
down until the 9-pin connectors and the plastic
snaps lock into place (see fig. 7). Be gentle when
attaching thermostat. If the thermostat does not
seem to be attaching to the subbase easily, make
sure that the connector pins and plastic snaps are
properly aligned, and that excess wire is pushed into
the wall. Damage to the thermostat may occur if
force is used.
ENGAGE TWO UPPER GUIDES; PIVOT DOWN
Figure 7. Attaching thermostat to subbase