Western Telematic NBB-1600-D20 User Manual
Page 10
2-2
NBB-1600-D20/D16 Series: Network Boot Bars - User's Guide
Manual Switch Button: A Manual Control Button for the unit’s
switched plugs. To manually switch plugs "On" or "Off", press and
hold the control button for approximately three seconds. If desired, the
Manual Switch Button can also be disabled (Section 5.3.1.)
Note:
When the Manual Switch Button is used, Boot / Sequence
Delay Times will be applied as described in Section 5.3.3.2.
Ready Indicator: Flashes when ready to receive commands.
Activity Indicator: Flashes to indicate activity at the Network Port.
10Base-T (Network) Port: An RJ45 Ethernet Port for connection to
your TCP/IP network. The default IP Address is 192.168.168.168, for
more information, please refer to Section 5.3.4.
RS232 Console Port: A DB9, RS232 serial port (DTE), for connection
to a local terminal or external modem, as described in Section 4.3.
Master Power Switch: This switch must be "On" in order for the NBB
to function. Note that this switch is not used to set the On/Off status of
the switched outlets.
Switched Plugs and Plug Indicators: For load ratings, please refer to
the instrument nameplate, and the table in Section 1.
• Model NBB-1600-D20: Sixteen (16) 100 to 120 VAC
NEMA 5-15R outlets, split into two separate power circuits.
Circuit A includes plugs 1 through 8, and Circuit B includes plugs
9 through 16.
• Models NBB-1600E-D20 and NBB-1600CE-D16: Sixteen (16)
100 to 240 VAC IEC320-C13 outlets, split into two separate power
circuits. Circuit A includes plugs 1 through 8, and Circuit B
includes plugs 9 through 16.
Power Circuit "A" Input Components: An IEC320-C20 AC inlet
and circuit breaker, which supply power to plugs one through 8. Also
includes two mounting screws for Cable Keeper:
• Model NBB-1600-D20: 100 to 120 VAC, 20 Amps.
• Model NBB-1600E-D20: 100 to 240 VAC, 20 Amps.
• Model NBB-1600CE-D16: 100 to 240 VAC, 16 Amps.