Western Telematic NBB-1600-D20 - Manual (Page 50)

6-6
NBB-1600-D20/D16 Series: Network Boot Bars - User's Guide
6.2.3. Applying Commands to Several Plugs - Text Interface
As described below, switching and reboot commands can be applied to only
one Switched AC Outlet, or to an assortment of outlets.
Notes:
• When switching or reboot operations are initiated, Boot/
Sequence Delay times will be applied as described in
Section 5.3.3.2.
• Switching and reboot commands will only be applied to the
outlets that are allowed by the password that was used to access
command mode.
1. Several Plugs: To apply a switching or reboot command to several
plugs, enter the numbers or names for the plugs, separated by a "plus
sign" ( +). For example to switch plugs 1, 4, and 5 Off, enter the
following:
/OFF 1+4+5 [Enter]
2. Series of Plugs: To apply a command to a series of NBB Plugs, enter
the number for the plugs that mark the beginning and end of the series,
separated by a colon. For example, to switch plugs 1 through 3 On,
enter the following:
/ON 1:3 [Enter]
3. All Plugs: To apply a command to all plugs, enter an asterisk in place
of the name or number. For example, to Boot all plugs, enter the
following:
/BO * [Enter]