ZyXEL Communications ZyXEL Dimension ES-2024 - Manual (Page 157)

Dimension ES-2024 Ethernet Switch
Introduction to CLI 25-7
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
delentry <vid> Deletes the specified (VID) static
VLAN.
active <vid> Turns on the specified static
VLAN.
inactive <vid> Turns off the specified static
VLAN.
list Displays a table of static VLANs.
vlan list <all|vid|start_vid end_vid> Shows the specified IEEE
802.1Q Tagged VLAN table.
status Shows the IEEE 802.1Q tagged
status.
driver config Shows the switch’s settings.
count disp Shows the switch Network Driver
Interface Specifications (NDIS)
level counters (CPU interface).
clear Clears the switch NDIS level
counters (CPU interface).
rstp
All “sys sw rstp” commands relate
to rapid STP configuration. Refer
to IEEE Std 802.1w. Use “config
save” to save your configuration
changes.
bridge
enable Enables RSTP.
disable Disables RSTP.
priority <priority> Sets the system priority.
maxage <Max_Age> Sets the max age timer
hellotime <Hello_Time> Sets the hello timer.
forwardDelay <Forward_Delay_Time> Sets the forward delay time
version <STP:0|RSTP:2> Displays/enables the STP mode;
STP or RSTP. RSTP is the
default used when configuring
STP via web configurator.
port
enable <port_no> Enables RSTP on this port.
disable <port_no> Disables RSTP on this port.
pathCost <Port_NO> <Cost|0:Auto> Sets the specified port’s path
cost.
priority <Port_NO> <Priority> Sets the specified port’s priority.
edgeport <port_no> Displays if this port is an edge
port.