ZyXEL Communications ZyXEL Dimension ES-2024 - Manual (Page 158)

Dimension ES-2024 Ethernet Switch
25-8 Introduction to CLI
Table 25-2 Command Summary: sys sw
COMMAND DESCRIPTION
p2pLink <Port_NO>
<Auto:2|True:1|False:0>
Sets whether the specified port
can connect to one bridge or
multiple bridges.
mcheck <Port_NO> Enables the Port Protocol
Migration state machine
(Disabled, Blocking, Listening,
Learning, Forwarding) on the
specified port.
disp Shows the RSTP runtime status.
trace [level] Sets the RSTP debug level.
lacp
Refer to IEEE 802.3ad for more
information on link aggregation
control protocol (LACP. It is
recommended that you use the
web configurator to configure
LACP parameters.
agg Displays aggregated ports.
port
enable <port_no> Enables LACP on the specified
port.
disable <port_no> Disables LACP on the specified
port.
status <port_no> Displays whether LACP is
enabled on the specified port.
actoradm activity [port_no]
[0:passive 1:active]
Allows/disallows the specified
local port to engage in link
aggregation.
actoradm display [port_no] Shows whether the specified
local port is engaged in link
aggregation.
actoradm key [port_no][key] Shows the specified local port
LACP key.
actoradm priority [port_no]
[priority]
Sets the specified local port
LACP priority.
actoradm timeout [port_no]
[0:long_timeout|1:short_timeout]
Enables a short or long timeout
on the specified local port.
keymgnt [on|off] Turns LACP key management on
or off.
syspriority <priority> Sets the LACP system priority.
The switch with the lowest priority
becomes the LACP “server”.
trace [level]
Sets the LACP debug level.
dot1x
“sys sw dot1x” commands relate
to IEEE 802.1X security.