ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 211)

GS-3012/GS-3012F User’s Guide
Introducing the Commands 30-17
Table 30-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
known-hosts Removes all remote hosts.
known-hosts <host-
ip> <cr>
Removes the specified remote
hosts from the list of all known
hosts.
known-hosts <host-
ip> [1024|ssh-
rsa|ssh-dsa]
Removes remote known hosts with
the specified public key (1024-bit
RSA1, RSA or DSA).
storm-control Disables broadcast storm control.
syslog Disables syslog.
server <ip> Disables a syslog server entry.
server <ip>
inactive
Enables a syslog server entry.
type <system,
interface,
switch,
authentication,
ip>
Sets the device to not generate a
category of logs.
timesync Disables the time setting on the
timeserver.
trunk <T1|T2|T3|T4|T5|T6>
lacp
Disables LACP in the specified
trunk group.
<T1|T2|T3|T4|T5|T6>
interface <port-
list>
Removes ports from the specified
trunk group.
<T1|T2|T3|T4|T5|T6>
<cr>
Disables the specified trunk group.
vlan <vlan-id> Deletes the static VLAN entry.
vlan1q gvrp Disables GVRP on the switch.
port-isolation Disables port isolation.
wfq fe-spq Sets the switch to use WFQ to
service all queues for the
10/100Mbps Ethernet port.
password Change the password for Enable
mode.