ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 214)

GS-3012/GS-3012F User’s Guide
30-20 Introducing the Commands
Table 30-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
ssh <socket-number> Allows SSH access on the
specified service port.
telnet <socket-
number>
Allows Telnet access on the
specified service port.
snmp-server [contact <system
contact>] [location
<system location>]
Sets the geographic location and
the name of the person in charge
of this switch.
get-community
<property>
Sets the get community.
set-community
<property>
Sets the set community.
trap-community
<property>
Sets the trap community.
trap-destination
<ip>
Sets the IP addresses of up to four
stations to send your SNMP traps
to.
spanning-tree Enables STP on the switch.
<port-list> Enables STP on a specified port.
<port-list>
priority <0-255>
Sets the priority for a specified
port.
<port-list> path-
cost <1-65535>
Sets the STP path cost for a
specified port.
hello-time <1-10>
maximum-age <6-40>
forward-delay <4-
30>
Sets Hello Time, Maximum Age
and Forward Delay.
priority <0-61440> Sets the bridge priority of the
switch.
spq Sets the queuing method to SPQ
(Strictly Priority Queuing).
ssh known-hosts <host-
ip> <1024|ssh-
rsa|ssh-dsa> <key>
Adds a remote host to which the
switch can access using SSH
service.
storm-control Enables broadcast storm control
on the switch.
syslog <cr> Enables syslog.
server <ip> inactive Disables a syslog server entry.
level <0-7> Sets which severity level(s) of logs
are sent to this syslog server. A
lower number is more critical.