ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 215)

GS-3012/GS-3012F User’s Guide
Introducing the Commands 30-21
Table 30-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
type <system,
interface, switch,
authentication, ip>
Sets the device to generate a
category of logs.
type <system,
interface, switch,
authentication, ip>
facility <0-7> Sets the facility (file) on the syslog
server to which the switch sends a
category of logs.
time <Hour:Min:Sec> Sets the time in hour, minute and
second format.
date
<month/day/year>
Sets the date in year, month and
day format.
timezone <-
1200|...|1200>
Selects the time difference
between UTC (formerly known as
GMT) and your time zone.
timesync <daytime|time|ntp> Sets the time server protocol.
server <ip> Sets the IP address of your time
server.
trunk <T1|T2|T3|T4|T5|T6> Activates a trunk group.
<T1|T2|T3|T4|T5|T6>
interface <port-
list>
Adds a port(s) to the specified
trunk group.
<T1|T2|T3|T4|T5|T6>
lacp
Enables LACP for a trunk group.
interface <port-
list> timeout
<lacp-timeout>
Defines the port number and LACP
timeout period.
vlan <1-4094> Enters the VLAN configuration
mode. See Section 30.9.4 for more
information.
vlan-type <802.1q|port-based> Specifies the VLAN type.
vlan1q gvrp Allows VLAN groups beyond the
local switch.
port-isolation Enables port isolation.
30.9.4 config-vlan Commands
The following table lists the config-vlan commands in configuration mode.
Table 30-4 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
vlan <1-4094> Creates a new VLAN group.
exit Leaves config-vlan mode.