Xerox 721P85530 - Manual (Page 117)

SPECIFYING INPUT PARAMETERS
XEROX DOCUPRINT 180 LPS PDL REFERENCE 4-29
[label:] SEFFNT SEFMAP
When coded outside of a standard JSL (either prior to a JDL
command or after an END command), a file containing the font
mappings by the name of label.LIB is created on a disk for reference
within the JSL by other JSLs or through a DJDE.
When specified without a label preceding the SEFFNT command,
this SEFMAP parameter puts all font mapping definitions within the
JSL, rather than creating a separate mapping file.
When coded at the catalog level, SEF mapping applies to all JOBS
or JDEs that include the catalog. When coded at the job level, SEF
mapping specifically assigns a mapping to be used with this JOB or
JDE.
Syntax [ label:]SEFFNT SEFMAP = option(s)
Options Table 4-35 lists the parameter option(s) and definition(s).
MAP
This parameter references a previously defined font mapping file
(
file-name) from a [label:]SEFFNT command.
Syntax [ label:]SEFFNT MAP = option(s)
Options Table 4-36 lists the parameter option(s) and definition(s).
Table 4-35. SEFMAP parameter option(s) and definition(s)
Option(s) Definition(s)
{( font
1
, font
2
)
[,( font
m
,, font
n
)] |
NONE}
This option has the following components:
• ( font
1
, font
2
)
Font pair, where font
2
is the SEF mapping for
font
1
.
•
( font
m
,, font
n
)
Font pair, where font
n
is the SEF mapping for
font
m
.
• NONE
Disables font mapping and short-edge feeding
(SEF); stops previous SEFFNT.
There is no default.
Table 4-36. Parameter option(s) and definition(s)
Option(s) Definition(s)
file-name References a previously created font mapping file
from a [
label:] SEFFNT command (assumes the label
already exists).
There is no default.