Xerox 721P85530 - Manual (Page 213)

PRINT FORMAT COMMANDS
XEROX DOCUPRINT 180 LPS PDL REFERENCE 6-47
DDE=[Y | N] Duplicate detection enablement. (Y)es indicates the
audit report will flag duplicate sheets delivered. This
option must be set to (N)o if multiple copies of a
report or pages within the report are printed. For out-
of-order deliveries, the job must be run in NOSEQ or
BAR ALI mode so that the IOT will not catch and
purge the mis-sequenced pages.
DAR=[SUM-WMGT|
SUM-OPLOG|
SUM-BOTH|
DET-WMGT|
DET-OPLOG|
DET-BOTH] The normal audit report option. DAR parameters are
a combination of a summary/detail option and an
exception data reporting option. For example, SUM-
WMGT specifies a summary report with waste
management data shown chronologically.
This summary/detail option cosists of:
• SUMmary
displays the audit report headings, the total of
sheets delivered to each destination, including
scrap, expected sheets if specified, and
reconciles reports amount if specified.
•
DETail
displays the audit report headings, detail
information about each sheet expected and
delivered, the total of sheets delivered to each
destination, including scrap, expected sheets if
specified, and reconciles reports amount if
specified.
The exception data reporting options consist of:
• WMGT
Specifies waste management data shown
chronologically.
•
OPLOG
Specifies system events, operator commands,
and responses that may relate to the production
of the report shown chronologically. Examples
would be a job abort, ESS boot, etc.
• BOTH
Specifies both WMGT and OPLOG.
Note: These options are specified as
compound keywords, for example ’SUM-
WMGT’. They are never specified alone; ’SUM’
is illegal.
RRA= nnn Report reconciliation amount (the total monetary
value of the report expected). Maximum of 11 digits
plus a decimal point may be specified. Commas are
not allowed. This option is required in order to print
an audit report reconciliation on amount.
NSE= sss Number of sheets expected for the report. Up to five
digits, for a maximum value of 99999, may be
specified. This option is required in order to print an
audit report reconciliation on number of sheets
consumed. The maximum value of 99999 takes into
account non-barcode pages in the report.
Table 6-36. BTEXT parameter option(s) and definition(s)
Option(s) Definition(s)