Xerox 721P85530 - Manual (Page 373)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 180 LPS PDL REFERENCE 8-43
Points to note
Note the following when using the FORMAT and FORMS
commands:
• Since there is ambiguity between the FORMAT and FORMS
parameters, if either is abbreviated to the first three letters, the
parameter defaults to FORMAT.
•
Paper size can only be changed in a job stream by using a JDE
to call out the desired paper size, that is, through the
PAPERSIZE parameter of the OUTPUT command. It is
important to change the image size when the paper size is
smaller than the current image so that all data is printed on the
page.