Xerox 721P85530 - Manual (Page 377)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 180 LPS PDL REFERENCE 8-47
The parameters T, H, and n/d are not order dependent. They may be
coded as needed without extra position holding commas.
If the UN parameter is used to define position, the UNITS parameter
must precede this command in the OUTPUT command.
Example IMAGE=(IMG1, 3, 2), END;
INVERT
This parameter specifies that the following pages are to be inverted.
When specified in a DJDE data stream (page oriented), this feature
allows the DocuPrint 180 to invert the image on a physical page by
180 degrees.
Syntax INVERT = option(s)
Options Table 8-32 lists the parameter option(s) and definition(s).
Table 8-36. INVERT parameter option(s) and definition(s)
Option(s) Definition(s)
FRONT Specifies page inversion on front sides.
BACK Specifies page inversion on back sides.
BOTH Specifies page inversion on both front and back
sides.
NONE Specifies turning page inversion off.