ZyXEL Communications GS-4012 - Manual (Page 335)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
335
<0-14> Accesses Enable mode
commands up to the privilege
level specified.
0
erase running-config Resets to the factory default
settings.
13
help Displays help information for this
command.
13
interface port-
channel <port-
list> [bandwidth-
limit...] Resets to the factory default
settings on a per port basis and
optionally on a per feature
configuration basis.
13
ethernet
oam remote-loopback
test <port> [<number of
packets> [<packet
size>]] Performs a loopback test from the
specified port, optionally specifies
how many and the size of packets
sent in the loopback test.
13
exit Exits Enable (or privileged) mode. 0
help Displays help information. 0
history Displays a list of command(s) that
you have previously executed.
0
igmp-flush Removes all IGMP information. 13
kick tcp <Session ID> Disconnects the specified TCP
session.
13
logout Exits Enable (or privileged) mode. 0
mac-flush Clears the MAC address table. 13
<port-num> Removes all learned MAC
address on the specified port(s).
13
no arp Flushes the ARP table entries. 13
arp inspection filter
<mac-addr> vlan
<vlan-id>
Specify the ARP inspection record
you want to delete from the
Switch. The ARP inspection
record is identified by the MAC
address and VLAN ID pair.
13
interface <port-number> Clears all counters on the
specified port.
13
logging Disables syslog logging. 13
ping
<IP|host-
name> Sends Ping request to an Ethernet
device.
0
[vlan <vlan-
id>][..] Sends Ping request to an Ethernet
device in the specified VLAN(s).
13
reload config <index> Restarts the system and use the
specified configuration file.
13
renew dhcp
snooping
database Loads dynamic bindings from the
default DHCP snooping database.
13
Table 138 Command Summary: Enable Mode (continued)
COMMAND DESCRIPTION PRIVILEGE