ZyXEL Communications GS-4012 - Manual (Page 361)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
361
igmp Enables and enters the IGMP
configuration mode.
13
exit Leaves the IGMP configuration
mode.
13
non-querier Sets the Switch to Non-Querier
mode. (If a multicast router with a
lower IP address, it will stop
sending Query messages on that
network.)
13
no non-querier Disables non-querier mode on
the Switch, (a multicast router
always sends Query messages).
13
unknown-
multicast-frame
<drop|flooding> Specifies the action the Switch
should perform when it receives
unknown multicast frames.
13
ospf <router-id> Enables and enters the OSPF
configuration mode.
13
area <area-id> Enables and sets the area ID. 13
area <area-id>
authentication Enables simple authentication for
the area.
13
area <area-id>
authentication
message-digest Enables MD5 authentication for
the area.
13
area <area-id>
default-cost
<0-16777214> Sets the cost to the area. 13
area <area-id>
name <name> Sets a descriptive name for the
area for identification purposes.
13
area <area-id>
stub Enables and sets the area as a
stub area.
13
area <area-id>
stub no-summary Sets the stub area not to send
any LSA (Link State
Advertisement).
13
area <area-id>
virtual-link
<router-id> Sets the virtual link ID
information for the area.
13
area <area-id>
virtual-link
<router-id>
authentication-
key <key> Enables simple authentication
and sets the authentication key
for the specified virtual link in the
area.
13
area <area-id>
virtual-link
<router-id>
authentication-
same-as-area Sets the virtual link to use the
same authentication method as
the area.
13
Table 139 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE