Yamaha AW1600 - Manual (Page 197)

Effects Parameters
197
AW1600 Owner’s Manual
Appendix
■ REV->PAN
■ DELAY+ER.
Parameter Range Description
REV TIME 0.3 – 99.9 s Reverb time
INI.DLY 0.0 – 500.0 ms Initial delay before reverb begins
HI.RATIO 0.1 – 1.0 High-frequency reverb time ratio
DIFF. 0 – 10 Reverb diffusion (left-right reverb spreed)
DENSITY 0 – 100% Reverb density
HPF Thru, 21.2 Hz – 8.0 kHz High-pass filter cutoff frequency
LPF 50 Hz – 16.0 kHz, Thru Low-pass filter cutoff frequency
FREQ. 0.05 – 40.00 Hz Modulation speed
DEPTH 0 – 100% Modulation depth
DIR. L<->R, L—>R, L<—R, Turn L,
Turn R Panning direction
WAVE Sine, Tri, Square Modulation waveform
REV BAL. 0 – 100% Reverb and panned reverb balance (0% = panned reverb, 100% = reverb)
MIX BAL. 0 – 100 [%] Mix balance of the effects and dry sounds
Parameter Range Description
DELAY L 0.0 – 1000.0 ms Left channel delay time
DELAY R 0.0 – 1000.0 ms Right channel delay time
FB.DLY 0.0 – 1000.0 ms Feedback delay time
FB.GAIN –99 to +99% Feedback gain (plus values for normal-phase feedback, minus values for reverse-phase feedback)
HI.RATIO 0.1 – 1.0 High-frequency feedback ratio
TYPE S-Hall, L-Hall, Random,
Revers, Plate, Spring Type of early reflection simulation
ROOMSIZE 0.1 – 20.0 Reflection spacing
LIVENESS 0 – 10 Early reflections decay characteristics (0 = dead, 10 = live)
INI.DLY 0.0 – 500.0 ms Initial delay before reverb begins
DIFF. 0 – 10 Reverb diffusion (left-right reverb spreed)
DENSITY 0 – 100% Reverb density
ER NUM. 1 – 19 Number of early reflections
HPF Thru, 21.2 Hz – 8.0 kHz High-pass filter cutoff frequency
LPF 50 Hz – 16.0 kHz, Thru Low-pass filter cutoff frequency
DLY/ER 0 – 100% Delay and early reflections balance (0% = early reflections, 100% = delay)
MIX BAL. 0 – 100 [%] Mix balance of the effects and dry sounds