Yamaha AW1600 - Manual (Page 83)

Preparing for mixdown
9
Mixdo
wn and bounce oper
ations
83
AW1600 Owner’s Manual
To prepare for mixdown, select the track channels that you will mix down, and adjust the balance
and tone of each track.
1
Lower the [STEREO] fader to the –
∞
posi-
tion.
2
In the Quick Navigate section, repeatedly
press the [RECORD] key or hold down the
[RECORD] key and use the CURSOR [
]/
[ ] keys to access the MIXDOWN page of
the RECORD screen.
The MIXDOWN page is where you can perform mix-
down operations. In this page you can select the chan-
nels that will be recorded via the stereo bus onto the
stereo track.
1 REC button
Puts the stereo track in record-ready mode.
B SAFE button
Defeats the record-ready state of the stereo track.
C LIBRARY button
Accesses the mastering library.
D Stereo bus
Indicates the on/off status of the channels being sent to
the stereo bus. The numbers within the screen corre-
spond to the following channels.
• INPUT 1–8 ..................Input channels 1–8
• P1–P4 .........................Pad channels 1–4
• TRACK 1–16...............Track channels 1–16
3
Use the [INPUT SEL] keys,
[TRACK SEL] keys, and pad
keys 1–4 to select the chan-
nels that you want to send to
the stereo bus.
The screen will change as follows
each time you press a key or pad
repeatedly.
4
If you want to use the mastering library,
move the cursor to the LIBRARY button and
press the [ENTER] key.
The MASTERING LIBRARY popup window will
appear. Turn the [DATA/JOG] dial to select the desired
library data, then move the cursor to the RECALL but-
ton and press the [ENTER] key.
Preparing for mixdown
4
2 1 3
• The track numbers of muted tracks will be displayed as “M”
(mute), but you can still record to muted tracks.
• Since 24-bit songs can have a maximum of 8 play tracks ( →
p. 143), tracks 9 – 16 are muted and will not play back.
NOTE
• All channels will be turned on by default. However in order to
obtain the best S/N ratio, you should turn off any channels
that you are not using.
• You can also add the signals of the input channels or pad
channels to the mixdown ( → p. 92).
HINT
• The mastering library contains data for loading EQ/dynamics
settings into the stereo output channel. (For details, refer to →
p. 78)
HINT