Yamaha AW1600 User Manual
Page 86
AW1600 Owner’s Manual
Using the internal effects via send/return
9
Mixdo
wn and bounce oper
ations
86
4
Move the cursor to the PRE/POST field in
the screen, and press the [ENTER] key to
specify the location from which the signal
will be sent from each channel to internal
effect 1.
Select POST if you want the volume of the effect
sound to be affected by the fader position. Select PRE
if you want to set the volume of the effect sound inde-
pendently of the fader position.
5
While you play back the song, move the
cursor to the EFF knobs in the screen, and
adjust the level of the signal that is sent
from each channel to internal effect 1.
6
To adjust the master level of the effect
send, repeatedly press the Selected Chan-
nel section [VIEW] key or hold down the
[VIEW] key and use the CURSOR [
]/[
]
keys to access the BUS page of the VIEW
screen.
The BUS page of the VIEW screen lets you use on-
screen faders to adjust the master level of each bus.
1 PEAK button
This is an on/off switch for the peak hold function of
the level meters. If this button is on, a peak indicator
will show the level meter peaks, and will remain
displayed. To reset this indicator, you can temporarily
switch the PEAK button off. This setting is shared
with the METER page of the VIEW screen.
B
PRE/POST button
This selects whether the level meters of the BUS page
will indicate the pre-fader level (PRE) or the post-
fader level (POST). This setting is independent from
the METER page of the VIEW screen.
C
AUX
D
EFF
E
BUS
Use these faders to adjust the master levels of AUX
buses 1/2, effect buses 1/2, and the L/R bus. The level
of each bus is indicated by the level meters at the right
of each fader.
7
Move the cursor to the fader for effect bus
1, and use the [DATA/JOG] dial to raise or
lower it.
• If the page you see is different than shown above, make sure
that track channels are selected as the object of your opera-
tions. (This is shown in the upper left of the screen.) If input
channels/pad channels are selected, press one of the
[TRACK SEL] keys.
NOTE
• Another way of adjusting the send level to internal effect 1 is
to press a [TRACK SEL] key to select a track channel, and
then turn the [EFFECT 1] knob of the Selected Channel sec-
tion. This method is convenient if you want to adjust the effect
level without displaying a different screen.
HINT
3
2
4
5
1
• You can also adjust the level of the return signal that is
returned from the internal effect to the mixer section. For
details, refer to “Editing the parameters of an internal effect”
(
HINT