ZyXEL Communications 10 - Manual (Page 131)

ZyWALL 10~100 Series Internet Security Gateway
Remote Node Setup 10-9
10.3.1 Editing TCP/IP Options (with PPTP Encapsulation)
Make sure that Encapsulation is set to PPTP in menu 11.1. Then move the cursor to the Edit IP field in
menu 11.1, press [SPACE BAR] to select Yes. Press [ENTER]
to open Menu 11.3 - Network Layer
Options.
Figure 10-6 Menu 11.3: Remote Node Network Layer Options for PPTP Encapsulation
The next table gives you instructions about configuring remote node network layer options.
Table 10-5 Remote Node Network Layer Options Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment If your ISP did not assign you an explicit IP address, select Dynamic;
otherwise select Static and enter the IP address & subnet mask in the
following fields. Dynamic
(default)
Rem IP
Address If you have a Static IP Assignment, enter the IP address assigned to
the remote node. 192.168.1.1
Rem IP Subnet
Mask If you have a Static IP Assignment, enter the subnet mask assigned
to the remote node. 255.255.255.0
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Addr= N/A
Rem Subnet Mask= N/A
My WAN Addr= N/A
Network Address Translation= SUA Only
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL: