ZyXEL Communications 10 - Manual (Page 136)

ZyWALL 10~100 Series Internet Security Gateway
10-14 Remote Node Setup
Table 10-6 Menu 11.1: Remote Node Profile (Traffic Redirect Field)
FIELD DESCRIPTION EXAMPLE
Edit
Traffic
Redirect Press [SPACE BAR] to select Yes or No.
Select No (default) if you do not want to configure this feature.
Select Yes and press [ENTER] to configure Menu 11.6 — Traffic Redirect
Setup. Yes
Press [ENTER] at the message “Press ENTER to Confirm...” to save your configuration, or press [ESC]
at any time to cancel.
10.5.1 Traffic Redirect Setup
Configure parameters that determine when the ZyWALL will forward WAN traffic to the backup gateway
using Menu 11.6 — Traffic Redirect Setup.
Figure 10-12 Menu 11.6: Traffic Redirect Setup
Table 10-7 Traffic Redirect Setup
FIELD DESCRIPTION EXAMPLE
Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
When the Active field is Yes, you must configure every field in this screen
unless you are using PPPoE or PPTP encapsulation (except Check WAN
IP Address and Timeout).
If you don’t configure these fields and are using PPTP or PPPoE
encapsulation, then the ZyWALL checks the PPPoE channel or PPTP
tunnel to determine if the WAN connection is down.
Yes
Menu 11.6 - Traffic Redirect Setup
Active= Yes
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 2
Period (sec)= 5
Timeout (sec)= 3
Press ENTER to Confirm or ESC to Cancel: