Xantrex Technology ACCB-L - Manual (Page 27)

Pre-Installation
973-0031-01-01 Rev A 2–5
Ventilation Requirements
Minimum clearance for ventilation around the Long AC Conduit Box must be at
least 12 inches (305 mm) at the top, the ends, and in front. This clearance is
needed to prevent recirculating hot air from the inverter’s exhaust (DC side) from
going back into the inverter’s intake (AC side).
Please refer to the Sine Wave Plus Inverter/Charger Owner’s Guide for additional
location considerations.
Figure 2-2 Clearance Requirements for Ventilation
12"
(305 mm)
12" (305 mm)
Required
WARNING
ELECTRICAL SHOCK
HAZARD
THIS ELECTRICAL SYSTEM IS EQUIPPED WITH A
DC TO AC POWER INVERTE R. DISCONNECT THE
DC AND AC SOURCES BEFORE SERVICING.
P N 355
0
Shock Hazard
Warning Label