Xantrex Technology ACCB-L - Manual (Page 32)

Installation
2–10 973-0031-01-01 Rev A
Installing Additional Breakers
If additional AC circuit breakers are to be installed for specific AC loads or a
generator disconnect, then install them per the manufacturer’s instructions on the
DIN Rail in the space to the left of the factory-installed AC Bypass Breaker. The
Long AC Conduit Box DIN Rail supports Square-D™, Type QOU, circuit
breakers.
To install additional Square-D™, Type QOU, circuit breakers in the Long
AC Conduit Box:
1. Remove the top cover as described on page 2–6.
2. Loosen the screw in the DIN Rail End Clamp and slide the clamp away from
the existing breaker.
3. Install the circuit breaker(s) on the DIN Rail to the right of the factory-
installed AC Bypass Switch. Be sure to align them to fit into the spaces made
by the knockouts that were removed on the top cover.
4. Slide the clamp tight against the last circuit breaker on the right and tighten
the screw to secure the clamp on the DIN Rail.
If creating an ACCB-L-L2 using the ACCB-L2-PCK add-on package, install the
second AC Bypass Switch to the right of the factory-installed AC Bypass Switch.
See the instructions provided with the package. Ensure the DIN Rail End clamp is
tight against the last breaker installed.
Figure 2-7 Installing Additional Breakers on the DIN Rail
DIN Rail
DIN Rail End Clamp
Factory-installed
AC Bypass Breaker