Xantrex Technology ACCB-L - Manual (Page 34)

Installation
2–12 973-0031-01-01 Rev A
3. Lift the inverter and place the mounting holes in the rail directly over the
mounting hooks on the panel and lower into place.
4. Install four ¼-20 phillips screws provided with the panel, into the mounting
holes of the Long AC Conduit Box, but do not fully tighten.
5. Lift the second inverter (if used) and place the mounting holes in the rail
directly over the mounting hooks on the panel and lower into place.
6. Install four ¼-20 phillips screws on the second inverter (if used) into the
mounting holes of the Long AC Conduit Box, but do not fully tighten.
7. Next, lift the Long AC Conduit Box and place the mounting hole in the rail
directly over the mounting hooks on the panel and lower into place.
8. Push the Long AC Conduit Box as close to the inverter(s) as it will possibly
go and secure it to the panel using four of the ¼-20 phillips screws provided
with the back plate hard ware kit. Torque to 76 in-lbs.
9. Tighten the mounting screws on the inverter(s) to the panel.
Torque to 76 in-lbs.
Important: Ensure the mounting hooks are visible through the holes in the mounting
rails. If you can not see the hooks, the unit is not installed properly and will not be secure
to the wall.
Figure 2-9 Installing the ACCB-L on the Backplate
Secure the Long AC
Conduit Box to the
back plate with
4 ¼-20 phillips
screws (provided).
Mounting hook
from back plate
for Long AC
Conduit Box Be sure the mounting hooks
are visible in the mounting rail
holes.