Xantrex Technology ACCB-L - Manual (Page 38)

Installation
2–16 973-0031-01-01 Rev A
Figure 2-11 ACCB-L Approved Internal Components
DIN Rail
(part of chassis -
all models)
Note: The ACCB-L comes
with the Ground bar only.
Some other mechanical
components can be pur-
chased from Xantrex (if part
numbers were given above)
or from the local electrical
distributor.
AC Input/Output Terminals
Marathon P/Ns:
• 1323572 (3 pole)
• 1320572 (1 pole)
or equivalent
AC Bus Bar (for L1 H OT )
Xantrex P/N:
• ACBUSBAR)
Includes two 10x32 phillips
screws and nuts, the bus bar and
plastic stand-offs to isolate it from
the chassis. Can be used for HOT
(L1 or L2), and/or neutral
connections.
Torque to 31 in-lb when installing.
AC Bypass Switch Assembly
(if not purchased at Xantrex)
Square D P/Ns:
• QOU160 (Single Breaker -
DIN Rail Mount)
• QOU260 (Dual Breaker -
DIN Rail Mount)
• QOU2DTILA (Mechanical
Interlock Attachment)
ILSCO P/Ns:
• SX-6 (x2) Service Crimps
DIN Rail End Clamp
Square D P/N:
• 999NT10 (10 pieces), or
IDEC P/N :
• BNL5
Ground Bar
(factory-installed)
AC Bus Bar (for Neutral)
Xantrex P/N:
• ACBUSBAR
Includes two 10x34 phillips
screws and nuts, the bus
bar and plastic stand-offs
to isolate it from the
chassis. Can be used for
HOT (L1 or L2), and/or
neutral connections.
Torque to 31 in-lb when
installing.
IMPORTANT: Always use
approved wiring per
NEC/CEC.