ZyXEL Communications ZYWALL10 - Manual (Page 119)

ZyWALL 10 Internet Security Gateway
8-2 SNMP
The following table describes the SNMP configuration parameters.
Table 8-1 SNMP Configuration Menu Fields
FIELD DESCRIPTION DEFAULT
Get
Community Enter the get community, which is the password for the
incoming Get- and GetNext- requests from the management
station. public
Set
Community Enter the set community, which is the password for incoming
Set- requests from the management station. public
Trusted Host If you enter a trusted host, your ZyWALL will only respond to
SNMP messages from this address. If you leave the field blank
(default), your ZyWALL will respond to all SNMP messages it
receives, regardless of source. blank
Trap
Community Enter the trap community, which is the password sent with each
trap to the SNMP manager. public
Destination Enter the IP address of the station to send your SNMP traps to. 0.0.0.0
Once you have completed filling in Menu 22 - SNMP Configuration, press [ENTER] at the
message “Press ENTER to Confirm” to save your configuration, or press [ESC] to cancel.