ZyXEL Communications ZYWALL10 - Manual (Page 35)

ZyWALL 10 Internet Security Gateway
Hardware Installation & Initial Setup 2-1
Chapter 2
Hardware Installation & Initial Setup
This chapter explains the LEDs and ports as well as how to connect the hardware and perform
the initial setup.
2.1 Front Panel LEDs and Back Panel Ports
2.1.1 Front Panel LEDs
The LEDs on the front panel indicate the operational status of the ZyWALL.
Figure 2-1 Front Panel
The following table describes the LED functions:
Table 2-1 LED functions
LEDS FUNCTION INDICATOR
STATUS
ACTIVE DESCRIPTION
PWR Power Green On The power adapter is connected to the ZyWALL.
Off The system is not ready or failed.
On The system is ready and running.
SYS System
Flashing The system is rebooting.
Green Off The 10M LAN is not connected.
On The ZyWALL is connected to a 10M LAN.
10M LAN LAN
Flashing The 10M LAN is sending/receiving packets.
Off The 100M LAN is not connected.
On The ZyWALL is connected to a 100Mbps LAN.
100M
LAN LAN Orange
Flashing The 100M LAN is sending/receiving packets.