ZyXEL Communications ZYWALL10 - Manual (Page 131)

ZyWALL 10 Internet Security Gateway
9-12 System Information & Diagnosis
Figure 9-11 WAN & LAN DHCP
The following table describes the diagnostic tests available in menu 24.4 for your ZyWALL and associated
connections.
Table 9-4 System Maintenance Menu Diagnostic
FIELD DESCRIPTION
Ping Host Enter 1 to ping any machine (with an IP address) on
your LAN or WAN. Enter its IP address in the Host IP
Address= field below.
WAN DHCP Release Enter 2 to release your WAN DHCP settings.
WAN DHCP Renewal Enter 3 to renew your WAN DHCP settings.
Internet Setup Test Enter 4 to test the Internet Setup. You can also test
the Internet Setup in Menu 4 - Internet Access.
Please refer to the Internet Access chapter for more
details. This feature is only available for dial-up
connections using PPPoE or PPTP encapsulation.
Reboot System Enter 11 to reboot the ZyWALL.
Host IP Address= If you entered 1 above, then enter the IP address of
the machine you want to ping in this field.
Enter the number of the selection you would like to perform or press [ESC] to
cancel.