ZyXEL Communications ZYWALL10 - Manual (Page 134)

ZyWALL 10 Internet Security Gateway
Firmware and Configuration File Maintenance 10-3
10.2.1 Example: Backup Configuration Using HyperTerminal
This section contains examples of backup configuration, restore configuration and upload firmware using
the HyperTerminal program. Other serial communications programs should be similar.
In menu 24.5 enter
y .
Run the HyperTerminal program. Click Transfer, then Receive File to display the following screen.
Figure 10-2 Example: Backup Configuration
10.2.2 Backup Configuration Using Telnet
Telnetting into the ZyWall produces this Backup Configuration screen.
Figure 10-4 Telnet into Menu 24.5 — Backup Configuration
Menu 24.5 – Backup Configuration
To transfer the configuration file to your workstation, follow the
procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the ‘rom-0’ file.
4. Type ‘get rom-0’ to back up the current router configuration to your
workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must
remain in the menu to back up using TFTP), please see your router manual.
Press ENTER to Exit:
Type a location for
storing the rom
configuration file, or use
Browse to look for one.
Choose the Xmodem
protocol.
Then click Receive.