ZyXEL Communications ZYWALL10 - Manual (Page 213)

ZyWALL 10 Internet Security Gateway
19-2 Example Firewall Rules
Step 1. Activate the firewall. You may activate the firewall through the ZyWALL Web Configurator as
shown next (click Configuration, the Config tab, then check the Firewall Enabled box) or
through SMT menu 21.2. You can only configure the firewall using the ZyWALL Web
Configurator or CI commands (see Appendices). When the firewall is active, the default rules
allow all traffic from the local network to the WAN (Internet) and block all traffic from the
Internet to the local network.
Figure 19-1 Activate The Firewall
Check here to activate the firewall.
You may also activate the firewall in
SMT menu 21.2.