ZyXEL Communications GS-3012F Series - Manual (Page 221)

Chapter 32 Introducing the Commands
GS-3012/GS-3012F User’s Guide
221
classifier <name>
<[packet-format
<802.3untag|802.3t
ag|
EtherIIuntag|Ether
IItag>] [priority
<0-7>]
[vlan <vlan-id>]
[ethernet-type
<ether-num|ip|ipx|
arp|rarp|
appletalk|decnet|
sna|netbios|dlc>]
[source-mac <src-
mac-addr>]
[source-port
<port-num>]
[destination-mac
<dest-mac-addr>]
[dscp <0-63> ]
[ip-protocol
<protocol-
num|tcp|udp|icmp|e
gp|ospf|rsvp|igmp|
igp|pim|ipsec>
[establish-only]]
[source-ip <src-
ip-addr> [mask-
bits <mask-bits>]]
[source-socket
<socket-num>]
[destination-ip
<dest-ip-addr>
[mask-bits <mask-
bits>]]
[destination-
socket <socket-
num>]
[inactive]>
Configures a classifier. A
classifier groups traffic into
data flows according to
specific criteria such as the
source address, destination
address, source port number,
destination port number or
incoming port number.
13
cluster <vlan-id> Sets the cluster management
VLAN ID.
13
member <mac-
address> password
<password-str> Sets the cluster member
switch’s hardware MAC
address and password.
13
name <cluster
name> Configures a name to identify
the cluster manager
13
rcommand <mac-
address> Logs into a cluster member
switch.
13
default-
management <in-band|out-of-
band> Specifies through which
traffic flow the switch is to
send packets.
13
dhcp-relay Enables DHCP relay. 13
Table 83 Command Summary: Configure Mode (continued)
COMMAND DESCRIPTION PRIVILEGE