ZyXEL Communications GS-3012F Series - Manual (Page 253)

Chapter 33 Command Examples
GS-3012/GS-3012F User’s Guide
253
33.8.9 weight
Syntax:
weight <wt1> <wt2> ... <wt8>
An example is shown next.
• Enable port two and ports six to eight for configuration.
• Set the queue weights from Q0 to Q7.
Figure 153 weight Command Example
33.8.10 egress set
Syntax:
egress set <port-list>
An example is shown next.
• Enable port-based VLAN tagging on the switch.
• Enable ports one, three, four and five for configuration.
• Set the outgoing traffic ports as the CPU (0) six (6), seven (7) and eight (8).
Figure 154 egress set Command Example
33.8.11 qos priority
Syntax:
qos priority <0 .. 7>
where
<wt1> <wt2>
... <wt8> Sets the interface WFQ weighting. A weight value of one to
eight is given to each variable from wt1 to wt8.
sysname# configure
sysname(config)# interface port-channel 2,6-8
sysname(config-interface)# weight 8 7 6 5 4 3 2 1
where
<port-list> Sets the outgoing traffic port list for a port-based VLAN.
sysname(config)# vlan-type port-based
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# egress set 0,6-8
where
<0 .. 7>
Sets the quality of service priority for an interface(s).