Xerox 721P85600 - Manual (Page 22)

LPS OVERVIEW
1-4 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE
Xerox DocuPrint 96/DocuPrint 96MX printer components
The printer is the part of the Xerox DocuPrint 96/DocuPrint 96MX
LPS that processes the electronic data and images received from the
system controller and produces the printed report. The parts of the
printer are shown in figure 1-5.
Figure 1-5. Xerox DocuPrint 96/DocuPrint 96MX printer
1 Processor feeder trays
2 Inverter feeder/stacker module
3 Purge tray
4 Attention light
5 Sample tray
6 Printer control console
Processor feeder trays Two processor feeder trays are located in the main part of the printer:
• The main tray (tray 1) holds up to 1100 sheets of 20 pound/75
gsm (grams per square meter) paper.
•
The auxiliary tray (tray 2) holds up to 600 sheets of 20 pound/75
gsm paper.
Inverter The inverter is part of the inverter feeder/stacker module. It allows for
proper collation of the print job. It also directs printed output to the
sample tray, when required.
High-capacity feeder There is a high-capacity feeder (HCF) tray located in the bottom half
of the feeder/stacker module.
The HCF tray can hold up to 2600 sheets of 20 pound/75 gsm paper.
High-capacity stacker There is a high-capacity stacker (HCS) bin located in the top half of
the feeder/stacker module.
The HCS bin can hold up to 2500 sheets of 20 pound/75 gsm paper.
Paper can be stacked directly onto the HCS pallet or into a specially-
designed container. Stacking capacity is approximately 100 to 150
sheets less when stacking into a container.