Z Microsystems 14 - Manual (Page 10)

Doc# 27-0001UM Issued 7/99 Rev. 1.2
Loosen the screws on
each of the front Z-Lock
mounts.
FINAL ADJUSTMENTS OF THE COMMAND CONSOLE
Slide the Console
partially out.
Use a flathead screw
driver to slightly move
the Z-Locks out away
from the Console.
Tighten all the screws on
the front Z-Lock mounts.
Slide the Console in and
out to see if it moves
smoothly.
Go back to the rear of
the rack and fully
tighten the slide
extension rail screw ((U)
see page 30 - Install
hardware ).screws.
Note: A wrench may be
necessary to hold the
nut on the other side.
Install Console
10