Z Microsystems 14 - Manual (Page 4)

Doc# 27-0001UM Issued 7/99 Rev. 1.2
The User Manual comes in two
formats: printed hardcopy or CD-
ROM. This Manual is also available
on the Z Microsystems website
(www.zmicro.com).
We recommend you read this manual
as follows:
Carefully follow the instructions in the
Installation and Testing chapter for
hookup and initial control settings.
Refer to the Operation chapter for a
complete description of all the user
controls, and the Maintenance and
Troubleshooting chapters for care and
correcting any unforeseen problems
with the system. The Appendices and
References chapters are provided for
quickly finding technical information
about the Command Console.
SYSTEM REQUIREMENTS
The Command Console works with
any computer system that provides
industry standard screen formats from
640 x 480 to 1024 x 768, with up to
75 Hz vertical sync. See the Specifica-
tions Table of this Manual for a
complete listing of all resolutions
supported.
The Command Console requires a
computer with a suitable onboard
subsystems for Video Adapter Card
that can support XGA 1024 x 768,
SVGA 800 x 600, or VGA 640 x 480
at 60 Hz
The Command Console shipping box
contains the following:
• The Command Console Unit
• Video Signal Cable
• AC/DC Power Supply Brick with
attached DC cable
• AC Power Cable
• Setup Diskette
• User Manual
Remember to save your original
shipping container and packing
material to transport or ship the
Command Console.
SHIPMENT CONTENTS
4