Install console, Install the command console in the slides, Test installation and make adjustments – Z Microsystems 14 User Manual
Page 9
Doc# 27-0001UM Issued 7/99 Rev. 1.2
INSTALL THE COMMAND CONSOLE IN THE SLIDES
Pull the two Console
slides out until they lock.
Hold the Console by
each side, with the front
toward you.
Feed the four cables
coming out of the
Console back through
the cabinet frame.
Guide the Console into
the slides and slide the
Console in until it stops.
Simultaneously press in
the catches on each
slide and slide the
Console all the way into
the cabinet frame.
The Console should
slide in and out easily.
Slide the Console in
and out several times.
The Console should
easily close completely.
To be sure the slide and
mount assembly are
aligned properly, slide
the Console in and out
several times.
If the Console binds
during sliding, do the
following:
Because of variances in
cabinet frames, there
may need to be some
adjustments of the
Console slide system for
best fit and movement
of the Console in and
out.
TEST INSTALLATION AND MAKE ADJUSTMENTS
Install Console
9