Starting point, Tools required precautions – Z Microsystems 14 User Manual

Page 6

Advertising
background image

Doc# 27-0001UM Issued 7/99 Rev. 1.2

TOOLS REQUIRED

PRECAUTIONS

Required Tools and Equipment
• Flathead screwdriver with about 10"

shaft.

• Phillips screwdriver with about 10"

shaft.

• Computer Setup Diskette

In preparation to install the Com-

mand Console, take the following

precautionary steps:
Turn off the electrical power to your

computer.
Verify the Command Console power

switch is off. If the Console is off, the

light will not be illuminated.

DANGER: To avoid shock hazard:
• Do not remove the covers around

the Command Console.

• Do not connect or disconnect the

Command Console during an

electrical storm.

• The power cord plug must be

connected to a properly wired

and grounded power outlet.

• Any equipment to which the

Command Console will be

attached must also be connected

to properly wired and grounded

power outlets.

NOTE: For the fastest and easiest

installation of the

Command Console, follow

these steps in the sequence

they are presented.

Starting Point

6

Advertising