Reference, Timing guide – Z Microsystems 14 User Manual
Page 19
Advertising
Doc# 27-0001UM Issued 7/99 Rev. 1.2
TIMING GUIDE
The monitor is not limited to these
preset factory-timing modes. In fact,
because the monitor is multi-scan-
ning, it can accept any signal within its
frequency range of 31.25KHz -
60.24KHz horizontal and 56Hz -
75Hz vertical.
If it is desired to use one of the preset
timing modes, refer to the video card
manufacturers installation guide for
instructions on how to make these
changes. The video card controls the
refresh rate. Most video cards provide
software utility or hardware DIP
switches that allow to change the
frequency used for each resolution.
* If using Macintosh, need Mac adapter.
Reference
19
Advertising