Z Microsystems 14 - Manual (Page 29)

Doc# 27-0001UM Issued 7/99 Rev. 1.2
INSTALL HARDWARE
· Install the slide assemblies to the rack by installing three screws (V) to the
front and three screws (W) to the rear.
· Tighten the hex nuts (U) that were installed in the previous page.
· Install the command console (FF) into the rack slides.
U. 01-91802 Nut 8-32 Nylon Hex
V. 01-92087 Scr, 10-32 x .375 Low Hd
W. 01-92097 Scr, 10-32 x .625 Pan Hd
FF. Command Console
29