Zebra 105SL - Manual (Page 104)

Configuration
Control Panel Parameters 96
11342L-001 Rev. A 105SL User Guide 6/30/06
These parameters are automatically set during the calibration procedure
and should be changed only by a qualified service technician. Refer to the
ZPL II Programming Guide for information on these parameters.
To skip these parameters:
1. Press PLUS (+) repeatedly.
Adjust LCD Display
This parameter allows you to adjust the brightness of your LCD if it is
difficult to read.
Default: 10
Range: 00 to 19
To change the value shown:
1. Press PLUS (+) to increase the value (increase brightness).
2. Press MINUS (-) to decrease the value (reduce brightness).
Select Format Convert
Selects the bitmap scaling factor. The first number is the original dots per
inch (dpi) value; the second, the dpi to which you would like to scale.
Default: NONE
Selections: NONE, 150
→ 300, 150 → 600, 200 → 600, 300 → 600
To change the value shown:
1. Press PLUS (+) or MINUS (-) to scroll through the options.
Table 9 • Printer Parameters (Page 18 of 19)
Parameter Action/Explanation
WEB S. 073
- +
MEDIA S. 075
- +
RIBBON S. 071
- +
- +
MARK S. 000
- +
MARK MED S. 000
- +
MEDIA LED 082
- +
RIBBON LED 008
- +
MARK LED 005
- +
LCD ADJUST +10
- +
FORMAT CONVERT
- NONE +