Ribbon overview, When to use ribbon, Coated side of ribbon – Zebra 105SL User Manual

Page 35: When to use ribbon coated side of ribbon

Advertising
background image

27

Printer Setup

Ribbon Overview

6/30/06

105SL User Guide

11342L-001 Rev. A

Ribbon Overview

Ribbon is a thin film that is coated on one side with wax, resin, or wax resin, which is
transferred to the media during the thermal transfer process. The media determines whether
you need to use ribbon and how wide the ribbon must be.

When ribbon is used, it must be as wide as or wider than the media being used. If the ribbon is
narrower than the media, areas of the printhead are unprotected and subject to premature wear.

When to Use Ribbon

Thermal transfer media requires ribbon for printing while direct thermal media does not.
To determine if ribbon must be used with a particular media, perform a media scratch test.

To perform a media scratch test, complete these steps:

1.

Scratch the print surface of the media rapidly with your fingernail.

2.

Did a black mark appear on the media?

Coated Side of Ribbon

Ribbon can be wound with the coated side on the inside or outside (

Figure 14

). This printer

can only use ribbon that is coated on the outside. If you are unsure which side of a particular
roll of ribbon is coated, perform an adhesive test or a ribbon scratch test to determine which
side is coated.

Figure 14 • Ribbon Coated on Outside or Inside

If a black mark...

Then the media is...

Does not appear on the media

Thermal transfer. A ribbon is required.

Appears on the media

Direct thermal. No ribbon is required.

Outside

Inside

Advertising