Zebra 105SL - Manual (Page 131)

123 Troubleshooting
Print Quality Problems
6/30/06 105SL User Guide 11342L-001 Rev. A
Fine, angular gray
lines on blank labels Wrinkled ribbon. See wrinkled ribbon causes and solutions in this
table.
Printing too light or
too dark over the
entire label Media or ribbon is not designed
for high-speed operation. Replace supplies with those recommended for
high-speed operation.
You are using an incorrect
combination of labels and
ribbon for your application. 1. Switch to a different type of media or ribbon
to try to find a compatible combination.
2. If necessary, consult your authorized Zebra
reseller or distributor for information and
advice.
You are using ribbon with
direct thermal media. Direct thermal media does not require ribbon. To
check if you are using direct thermal media,
perform the label scratch test in
When to Use
Ribbon on page 27 .
If you are using ribbon intentionally with direct
thermal media, increase the darkness level, but
note that high darkness levels may decrease
printhead life. You may wish to perform the
FEED Self Test on page 134 to determine the
ideal darkness setting.
Incorrect or uneven printhead
pressure. Set the pressure to the minimum needed. See
Printhead Pressure Adjustment on page 70 .
Smudge marks on
labels Media or ribbon is not designed
for high-speed operation. Replace supplies with those recommended for
high-speed operation.
Misregistration/skips
labels The printer is not calibrated. Recalibrate the printer.
Media sensor is not positioned
correctly. Perform media sensor position adjustment.
Improper label format. Use correct label format.
Misregistration and
misprint of one to
three labels The platen roller is dirty. See Clean the Printhead and Platen Roller
on page 109 .
Media sensor is not positioned
correctly. Place media sensor in proper position.
Media does not meet
specifications. Use media that meets specifications.
Table 13 • Print Quality Problems (Continued)
Problem Possible Cause Recommended Solution