Clean the media compartment and sensors – Zebra 105SL User Manual
Page 120
Routine Maintenance
Clean the Media Compartment and Sensors
112
11342L-001 Rev. A
105SL User Guide
6/30/06
Clean the Media Compartment and Sensors
After every four rolls of media, inspect the media compartment. Use a soft bristle brush or a
vacuum cleaner to remove any dirt and lint from the interior of the printer.
The sensors should be cleaned on a regular basis to ensure proper operation of the printer.
Brush or vacuum any accumulated paper lint and dust off of these sensors.
To clean the media compartment and sensors, complete these steps:
1.
Brush or vacuum any accumulated paper lint and dust away from the media and ribbon
paths.
2.
Brush or vacuum any paper lint and dust away from the sensors.
Figure 30 • Upper Media Sensor Assembly
Figure 31 • Lower Media Sensor Assembly