Zebra 105SL - Manual (Page 129)

121 Troubleshooting
LCD Error Messages
6/30/06 105SL User Guide 11342L-001 Rev. A
The printer stops and the
ERROR light flashes.
Caution • An improperly connected printhead data or power cable
can cause this error message. The printhead may be hot enough to
cause severe burns. Allow the printhead to cool.
The printhead is under
temperature. Continue printing while the printhead
reaches the correct operating
temperature. If the error remains, the
environment may be too cold for
proper printing. Relocate the printer to
a warmer area.
The printhead data cable is not
properly connected.
Caution • Turn the printer
off (
O) before performing this
procedure. Failure to do so
can damage the printhead.
1. Turn off ( O ) the printer.
2. Disconnect and reconnect the data
cable to the printhead.
3. Ensure that the cable connector is
fully inserted into the printhead
connector.
4. Turn on ( I ) the printer.
There is not enough memory to
perform the function specified on
the second line of the error
message. Free up some of the printer’s memory
by adjusting the label format or printer
parameters. One way to free up
memory is to adjust the print width to
the actual width of the label instead of
leaving the print width set to the
default. See
Set Print Width
on page 82 .
Ensure that the device, such as FLASH
memory or PCMCIA card, is installed
and not write protected or full.
Ensure that the data is not directed to a
device that is not installed or available.
Refer to the Maintenance Manual for
more information about the specified
function.
Table 12 • LCD Error Messages (Continued)
LCD Display/
Printer Condition
Possible Cause Recommended Solution
WARNING
HEAD COLD
OUT OF MEMORY
(function)