Xerox MAX 200 - Manual (Page 183)

How to customize the MAX 200 181
How to change the system features (continued)
Document width
Introduction
The document width feature sets up the document series the
scanner recognizes in auto mode.
Procedure
1. Enter custom presets. If needed, refer to page 174.
2. Select the system features tab.
3. Use the arrow buttons to select the document width feature.
4. Select open.
The document width screen is displayed.
5. Select 8.5 inch or 9 inch.
6. Select done to store your changes and exit from this screen.
To cancel the changes and exit from this screen, select cancel.
7. To exit, press the custom presets button.
Custom Presets
9 inch 8.5 inch
Cancel Done Document Width
Select document width, 8.5 inch or 9 inch
Press [Custom Presets] to return to
Previous screen.
System features Copy features
Storage/Disk
Manager
Open
Time &Date
Auto Power Off
Auto Power save
Auto Clear/ Backlight Off
Attention Tone
Document Width
Plotter Setup
Loading Stamp Data