Xerox MAX 200 - Manual (Page 187)

How to customize the MAX 200 185
How to change the system features (continued)
Plotter setup (continued)
Set delay time to copy mode
Procedure
1. Enter custom presets. If needed, refer to page 174.
2. Select the system features tab.
3. Use the arrows to select the plotter setup feature.
4. Select open.
The plotter setup screen is displayed.
5. Select set delay time to copy.
The set delay time to copy screen is displayed.
Press Custom Presets to return to
Previous screen.
System features Copy features
Storage/Disk
Manager
Open
Time &Date
Auto Power Off
Auto Power save
Auto Clear/ Backlight Off
Attention Tone
Plotter Setup
Loading Stamp Data
Set Default
Time to Plot
Set Delay
Time to Copy
Folder
30 seconds Delay Set
3 Minutes No Fold
Plotter Setup
Cancel Done
Custom Presets