Z Microsystems ZX Station - Manual (Page 10)

Document# 27-0007UM Issued 11/00 Rev. 1.0
INSTALL THE ZX STATION IN CABINET FRAME
Pull the two ZX Station
slides out until they
lock.
Hold the ZX Station by
each side, with the front
towards you.
Guide the ZX Station
into the slide rails and
slide the ZX Station in
until it stops. If the ZX
Station binds, the
rollers are not properly
in the slide rails.
Simultaneously press in
the catches on each
slide and push the ZX
Station all the way into
the cabinet frame.
The ZX Station should
slide in and out easily.
Install ZX Station
10
INSTALLATION TEST
Slide the ZX Station in
and out several times.
The ZX Station should
easily close completely.
To be sure the slide and
mount assembly are
aligned properly, slide
the ZX Station in and out
several times.
If the ZX Station binds
during sliding, do the
following: