Z Microsystems ZX Station - Manual (Page 24)

Document# 27-0007UM Issued 11/00 Rev. 1.0
CLOSING THE ZX STATION
To close the ZX Station, reverse the above steps:
24
One of the many design features of the ZX Station is the ease of access to the
inside of the processing unit. To open the ZX Station in the rack, perform the
following steps:
OPENING THE ZX STATION
Be sure the power
switches on the front
and back are off.
Disconnect all the
cables from the back of
the ZX Station to their
respective units.
Remove the four
pancakehead Phillips
screws on the bottom
of the ZX Station (upper
two and lower right
two).
Remove the six
panhead Phillips
screws on the sides of
the top lid.
Remove the four
ovalhead Phillips
screws on the corners
of the front panel and
sliding the ZX Station
all the way out.
Slide the ZX Station out
until reaching the safety
stop.
(cables into back of
ZX Station)
Remove the two
pancakehead Phillips
screws on the top front
of the ZX Station lid.
Carefully lower the front
panel.
Disconnect cables to
components inside ZX
Station.
The entire inside and
back of the front panel
of the ZX Station is now
accessible.
Internal Access