Z Microsystems ZX Station - Manual (Page 12)

Document# 27-0007UM Issued 11/00 Rev. 1.0
12
Several cables connect the back of
the ZX Station to other equipment,
depending upon the ZX Station
internal configuration.
• Power cable
• Video cable
• Printer cable
• Keyboard cable
• Mouse cable
• and others
WARNING: Be sure all electrical
power to the cabinet is off
before connecting any of the
cables.
WARNING: There is a key guide for
alignment on all the cables.
Be sure the cable plug and
receptacles are aligned
properly using the key
guide. Misalignment can
cause short circuiting.
INSTALLING CABLES
The power cable
coming out of the back
of the ZX Station should
be connected to an
appropriately grounded
110 VAC supply.
After connecting the
power cable, turn the
power switch next to
the power cable in the
back to the on position
(circle down) and leave
it on until disconnect
the power cable.
Install ZX Station