Z Microsystems ZX Station - Manual (Page 18)

Document# 27-0007UM Issued 11/00 Rev. 1.0
Operation
INSTALLING DISK MODULE
NOTE: The disk module can be
installed with the disk
module handle in any of its
five positions and the
function switch in any of its
four positions. However, it
is recommended that the
handle be pulled out and
that the function switch be
in an unlocked mode. If
the disk module is plugged
into the docking base with
its handle in Position 1, the
hard disk will immediately
start to spin up.
Although the handle does not have
to be used for supporting the module
during installation, it is designed as
an installation aid by holding the
entire weight of a loaded disk module
in any position.
It allows the disk module to be held
with one hand so that it can be guided
into the docking base with the other
hand.
With the handle extended from the
disk module, grasp the handle and
guide it into the docking base.
Push firmly on the disk module front
panel until the disk module is fully
seated.
You will hear a snap or a click that
indicates the module latch locking
mechanism is engaged.
The center active light (green LED) on
the front panel will blink, indicating
that there is power going to the disk
module.
NOTE: Refer to the TranzPak 6 User
Manual for details about
system operations.
18