Z Microsystems ZX Station - Manual (Page 11)

Document# 27-0007UM Issued 11/00 Rev. 1.0
FINAL ADJUSTMENTS
Install ZX Station
11
Slide the ZX Station
partially out.
Lift the ZX Station while
tightening the
pancakehead Phillips
screws in the front slider
bracket.
Go to the rear of the
cabinet to tighten the
slider rail screws. If
there is not enough
room to work at the
back of the cabinet, the
ZX Station may need to
be removed to tighten
the rail screws.
The ZX Station should
now slide in and out
smoothly. If not, repeat
these steps.
SECURING ZX STATION IN CABINET FRAME
Use four ovalhead
Phillips screws, stainless
steel and nylon recep-
tacle washers to secure
the front panel of the ZX
Station to the front of
the cabinet frame.
The ZX Station should
slide in and out easily.
If not, repeat these
adjustment steps.